How To Swap Out Handlebars On Motorcycle?

Certainly, some people want to swap handlebars as well as motorcycle handlebar covers for a lot of reasons. To be honest, If you want to change the handlebar, your motorcycle will take on a new appearance. For example, if you change the handlebar and motorcycle handlebar lock, you may regard your motorcycle as a new one.

As changing the handlebar can be an easy operation, you do not need to worry whether you can do it by yourself. Actually, it is also simple for people to exchange a stock motorcycle mirror, handlebar clamps, and motorcycle wheels but the difficulty will gradually increase if you want to rearrange the switch, change hydraulic hoses, or customize other parts like motorbike tyre valves.

There is no doubt that people should choose handlebars carefully because a lot of details will influence their functions. For example, if your motorcycle is not as comfortable as before, you may wonder whether the handlebar is the cause. You should adjust the handlebar to a suitable location for you. Firstly, you should make the bike upright and sit on the saddle with your feet resting naturally on the motorbike pedals. Then, you should keep relax, reach out, and put your hands correctly. Finally, you should see the exact angle of your handle so that you can find the most suitable location.

Thus, how can you change the handlebars on a motorcycle? First of all, you should take the old one-off. You should change the handlebars like custom handlebars before you are going to replace the hoses or master cylinders of your motorcycle. As we all know, there are plenty of components of motorcycles such as motorcycle exhaust valves so that we should be patient and prudent to avoid influencing other components of motorcycles.

After that, you should install the new most comfortable motorcycle handlebars. If there are no problems, you should start the installation of the new handlebar. If you are keen on its bar-end fitting, you can directly purchase a new one. As other bikes from the same manufacturer use the same bar-end fittings, you can get it specifically for your ride.

It is vibration control’s turn now. If the handlebar is vibrated, there are some tips which can do you a favor to reduce the buzz. You should make sure that any rubber mounts and in good condition. To change vibration characteristics, you have to change the frequency of the moto handlebars. As a result, changing the length will have some negative effects.

Finally, you should get it wired. You can extend wires in different ways. To be honest, the easiest way is to splice in the new wire where it's needed. You should use the wire rather than using those press-on splice connectors as connectors tend to be unreliable and are probably too bulky to slide through the bar. You have to keep n mind that you should cover the splices with heat-shrink tubing to strengthen the splice and prevent shorting. In brief, it is not so complicated for people to change the handlebars of motorcycles. They have to be careful enough to finish this task.